MOTindex

Common Land Rover MOT failures

Based on 9 Land Rover tests on MOTindex carrying an official DVSA defect code, so every category below is counted from real failures rather than estimated.

Full Land Rover MOT data, pass rate and models →

Real DVSA defect codes

Every category comes from the official MOT Inspection Manual section code DVSA attaches to each defect, not guessed from keywords.

Choose a make or model

Filter the chart below to one make or one specific model, and it updates without leaving the page.

Grows more accurate over time

Built from tests recorded on MOTindex, so the picture firms up as more vehicles are checked here.

See the breakdown for one make or model

Defaults to every make checked on MOTindex.

Where MOT tests find problems: Land Rover

Axles, wheels, tyres and suspension 3 tests (33.3%)
Visibility 1 test (11.1%)

A test can find problems in more than one category, so the figures above do not sum to 100%. Each percentage is the share of classifiable tests that found at least one defect in that category. Based on 9 classifiable tests for Land Rover.

View the full Land Rover page →

What Land Rover failures look like

9 Land Rover tests recorded on MOTindex carry the manual reference DVSA attaches to each defect. The most frequent problems were with axles, wheels, tyres and suspension on 3 tests (33.3%) and with visibility on 1 test (11.1%). A test can fail on more than one thing, and an MOT can be failed on one defect while another is only advised, so these counts do not add up to the number of tests.

Narrowed down from the categories to the individual defects themselves, one of them comes up on more than one test:

  • Tyre worn close to legal limit/worn on edge

    MOT inspection manual reference 5.2.3, in axles, wheels, tyres and suspension

    Recorded on 3 of the 9 tests: one failure and 2 advisories or minors.

One Land Rover model has its own breakdown: Land Rover Range Rover Sport (9 tests).

Clauses are read from the manual reference at the end of every defect on the cached test records, and a defect shown here has to appear on at least two of them before it is named. The site-wide breakdown explains how that works and compares every make.